Comp II 2 Sport LED 6-Gauge Auto Gauge Meters HOT WHITE w/ BLACK Bezel USA Made

Description

NOTE:
You MUST indicate fuel gauge preference when ordering or you WILL get the default pre-1985 Ford fuel gauge
Comp II LED - HOT WHITE Sport Dials
Black Anodized Aluminum Bezel Rings
Flat Glass Lens - WHITE Through the Dial LED Lighting
If you  own an American Made Project Car, then don't go cheap by getting foreign made gauges...
2-1/16" gauges feature the new "no screw, dial forward" design.
These enhancements bring the dial forward, eliminate any light showing around  the edges of the dial at night, for a cleaner, high-end appearance.
Features:
High quality gauges made in Orange County, CA USA.
High-speed full sweep stepper motor speedometer and tachometer
Short sweep electric 2-1/16" gauges (Volts, Oil Pres, Water Temp, Fuel Level)
Electric programmable speedo with one-step easy calibration and 2 Trip meters
Fuel level gauge available in 5 different ranges (*see below for more info)
WHITE through-the-dial LED lighting for a clear and easy view at night
3D glowing pointer
for easy visibility at night
WHY SPEND MORE ON SIMILAR
SPORTY COMP TYPE AUTO GAUGE METERS or worse, settle for mass produced
gauges
from overseas?!
Set Includes:
3-3/8" Electric Programmable Speedometer, 0-160 MPH
3-3/8" In-Dash 0-10k RPM Tachometer
2-1/16" Volts, 8-18V
2-1/16" Oil Pressure, 0-80 PSI with sender
2-1/16" Water Temperature, 120-280F with sender
2-1/16" Fuel Level Empty-Full, 73-10 Ohm Stock '66 Mustang input range (default)
The oil pressure and water temp sending units are included.
NOTE
:    The volts gauge does not require a sender.
NOTE
:
The tachometer does not require a sender - you get the signal from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or ignition box).
Through-Dial LED Lighting
This set features through-the-dial LED lighting and glowing 3D pointer for a  cool look and easy viewing at night.
This set is assembled in Orange County California, USA.  Please allow 2-3 days  for your item to be made before it ships.
Bezel Rings:
The Comp II LED Sport Classic Black Gauge Set comes with the bold yet classic look of Polished Stainless Steel Bezel Rings for that
Traditional Look
The Fuel Level Options:
This Set comes with the FORD 73-10 ohm Fuel Gauge (Most pre '85 Fords)
If you require a different fuel gauge for your sending unit (listed below) indicate this in the notes during
checkout
-
otherwise you will get the pre '85 FORD & Mopar fuel gauge
Options:
73-10 ohm (most FORD pre '85)
20-150 ohm (most Ford after '85)
0-90 ohm (most GM after '65)
240-33 ohm (most generic aftermarket sending units)
0-30 ohm (SEE NOTES)
NOTES:  For those needing 0-30 Ohm Fuel gauges, order the 0-90 and optional
Programmable Fuel Level Gauge Interface
eBay item number:
192819182455
https://www.ebay.com/itm/192819182455
Speedometer  Signal Generator
Options:
Please select if you need a signal generator - defaults to NONE
Speedometer will work with any OEM or aftermarket speed sensor or electronic  module that meets the following conditions:
Pulse range generated proportional to the vehicle speed
Signal with minimum 3V peak to peak signal - typical for 3-wire hall    effect and 2 wire vehicle speed sensor outputs
output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm)
If you currently have a mechanical speedometer (cable driven) you will need a  hall effect sender.  After you add this gauge set to your shopping cart,
See Our  Other Items
to add the  correct hall effect  sender to your shopping cart.  The hall effect sender installs on your current  transmission cable take off location. The signal from the hall effect sender  (12V Square Wave signal) drives the electric speedometer.