(2pc) Red Black 345 Badge Emblem Chrome Trim for MOPAR HEMI Charger Challenger

Description

SIZE : 6.75" Wide x 1.25" Tall; 3/8" Thick
New 345 HEMI emblem Red with black outline includes alignment sheet
(
Auction is for 2 emblems
)
Important
Vehicle Emblem and Badge Installation Instructions
Step 1
Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper.
Step 2
Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag.
Step 3
Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry.
Step 4
Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body lines. Use painter’s tape to make your guide lines.
Step 5
Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after  Remove the backing tape from the adhesive.
Step 6
Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located properly.
Step 7
Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually takes 10 seconds..